Was this a 5.4 change? Very important since I haven't migrated our
systems from 5.3 to 5.4 yet. I have a test build running on a single cpu
box without smp enabled. Would have sucked if I hadn't known that ahead
of time...
On Tue, 17 May 2005, Kris Kennaway wrote:
On Tue, May 17, 2005 at 01:05:26PM -0400, Jason Lieurance wrote:
Hello,
I have a new Dell PowerEdge Dual Xeon 2.8 server and the freebsd install 'sees'
1
cpu. It loads the HT right but doesn't see the 2nd cpu at all. I went to rebuild
kernel and 'options smp' is not even a choice. I add it along with the others
that
are mentioned for smp and when I run config it says in effect, 'doesn't
understand
smp option', meaning it can't be added. Didn't think setting up smp on bsd
would be
this much trouble. Any advice? Thanks.
'options smp' is indeed not the choice :-)
Check the documentation (e.g. handbook, sample kernel configurations)
for precise instructions.
Kris
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
