You can low level format any hard drive. Just go to the manufacturer's
website and download the utility.
-Derek
At 05:30 PM 5/26/2006, Gerard Seibert wrote:
Derek Ragona wrote:
> If you have nothing of value on the hard drive, I would suggest low-level
> formatting the drive, then verify the boot order is CD first.
>
> -Derek
>
>
> At 04:22 PM 5/26/2006, Jason Curole wrote:
> >Hello all,
> >
> >I am a newbie to FreeBSD, though I currently use Mac OS X and am
> >reasonably comfortable with the unix side. I am trying to install
> >FreeBSD on a Dell Precision 210 machine (scrounged it up recently and
> >it has a huge hard drive, otherwise I don't know much about it). I
> >have tried installation with FreeBSD Release 6.0 and 6.1 (both the
> >full cd and boot-only cd for 6.0; just the boot-only cd for 6.1).
> >The machine boots and I get to the screen where I can select my boot
> >option. I select 5, (boot with detailed messaging) and the machine
> >goes through some SMAP messages, a couple of Copyrights and a Free- BSD
> >claimer with an email address. It pauses here for a good
> >10-15min. Then I get messages regarding preloading of "elf kernel",
> >"mfs_root" and "elf module", followed by tables 'FACP' and 'APIC',
> >"MADT: Found table at ...", "APIC: Using the MADT enumerator", then:
> >
> >MADT: Found CPU APIC ID 0 ACPI ID 1: enabled
> >MADT: Found CPU APIC ID 1 ACPI ID 2: disabled
> >
> >It has remained at this point for at least a half-hour (through
> >lunch, etc.), no lights flashing and does not respond to the enter
> >key. Is this normal? I should mention that between the attempt at
> >installing 6.0 (about 4 weeks ago) and 6.1 I had installed OpenBSD
> >and it appeared to install and work fine, so I think the machine is
> >okay.
> >
> >Jason
I did not think it was possible to low level format a modern HD.
--
Gerard Seibert
[EMAIL PROTECTED]
"Never underestimate the power of stupid people in large groups."
Anonymous
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
MailScanner thanks transtec Computers for their support.
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
MailScanner thanks transtec Computers for their support.
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
