Completely ignore me. Write caching wasnt turned on.
Cheers
Richard
Richard Collyer wrote:
Hello,
I recently installed a 3ware 9500S-12 along with 3 x 250GB Seagate
7200.10 Drives.
I am getting very poor read/write performance on this array that I have
set up (RAID5 - 64K stripe)
Reading to the 2 mirrored drives that I have on a 3ware 7006-2 I can get
8MB/sec over samba which is what I expect. From the new array I am
getting 4MB/sec. To rule out samba I did a file copy from one array to
the other an averaged 3.8MB/sec which I assume is being limited by the
new array.
Any ideas where I can check to see if there are problems and what are
the first steps / common things that people miss when adding drives.
In short I...
a) installed the drive
b) disk partitioned using /stand/sysinstall
c) labelled using the same
d) edited /etc/drivetabthingy to mount the drive
Anyone else have any other suggestions on what I can check?
Cheers
Richard
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to
"[EMAIL PROTECTED]"
__________ NOD32 1.1674 (20060722) Information __________
This message was checked by NOD32 antivirus system.
http://www.eset.com
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
