Matthew Pope wrote:
Matthew Pope wrote:
Lowell Gilbert wrote:
Matthew Pope <[EMAIL PROTECTED]> writes:
[...]
for temp file for many of the prompts. Now my 5.5 kernel boots, but
there are a number of messages of the form:
source_rc_confs: not found
$ipnat_enable is not set properly - see rc.conf(5)
$ipfs_enable is not set properly - see rc.conf(5)
etc....
[...]
I later read in the mailing list that someone had a simliar problem
and solved it by re-running the mergemaster step. I tried that too,
and this time I selected <default> answer to all the prompts about
conflicts.
The default operation in mergemaster is to do nothing, so if you're
going to choose the default the whole way, you might as well skip
running mergemaster at all.
Yes, well put. That clarified I was in fact consuming resources in a
less than optimal way :-)
Go back through mergemaster, and actually
pay attention to the changes. On files you haven't modified, you will
be able to (i)nstall the new versions of those files, but otherwise
you will need to (m)erge them.
Ok, I tried that but my system is too far gone. Close to 100
environment vars are missing and if I jam them all into rc.conf it
will be a mess, especially since I would be guessing at the
appropriate values for the vars.
My next step is to start from scratch (as Albi suggested.)
Unfortuntely, even with ipfw set to open, I am still getting no route
to host when I try and ping my gateway.
It was always pingable in the past, and I've checked the cable into
my new-ish switch and all seems fine, with green lights. The result
of a route -n is in another virtual terminal and I can't copy and
paste, but it lists the headers and then nothing for the details,
i.e. no routes are in the routing table at all.
OK pen and paper come to the rescue, here is the result of netstat -n
on my misconfigured, 5.5 stable, upgraded system that can not seem to
ping the gateway let alone do a cvsup:
Active UNIX domain sockets
Address Type Recv-Q Send-Q Inode Conn Refs NextRef Addr
c20761a4 Stream 0 0 c207a000 0
0 0 /var/run/devd.pipe
I tried trying ifup sis0 but I discovered ifup is no longer around.
Thanks,
Matthew
OK found the problem using ifconfig. As a result of the botched
rebuild, (my bad), my netword card was given an IP_V6 address but no
IP_V4 address.
I used
# ifconfig sis0 add 10.1.1.99
This put me back in touch with the world on this server. Now I can cvsup
to a production 'Release' version of FreeBSD, and rebuild all.
Will tag=RELENG_6_1 for cvsup be the latest 'Release' then of FreeBSD,
not stable, nor current, but Release?
Thanks in advance,
Matthew
Further suggestions welcome, and thanks for your help so far.
Sincerely,
Matthew
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to
"[EMAIL PROTECTED]"
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to
"[EMAIL PROTECTED]"
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to
"[EMAIL PROTECTED]"
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"