Each BIOS maps beep codes into a diagnostic message. Also, are you getting video signal/BIOS on your monitor? ~BAS
On Tue, 2007-03-27 at 14:47 -0500, David J Brooks wrote: > On Tuesday 27 March 2007 02:29:29 pm Jason Gretz wrote: > > Hey guys I am adding a hard drive to my FreeBSD 6.1 box and it stalls > > during booting and makes a beeping noise. I know the hard drive is good > > because I just swapped it out of another FreeBSD box… > > > > So I’m kinda stumped, is there anyways to troubleshoot this? I can’t even > > boot in “safe” or “single-user mode” > > Check the jumper settings on the drive itself. You may be trying to add a > drive configured as Master into a chain that's expecting a Slave. > > David -- Brian A. Seklecki <[EMAIL PROTECTED]> Collaborative Fusion, Inc. IMPORTANT: This message contains confidential information and is intended only for the individual named. If the reader of this message is not an intended recipient (or the individual responsible for the delivery of this message to an intended recipient), please be advised that any re-use, dissemination, distribution or copying of this message is prohibited. Please notify the sender immediately by e-mail if you have received this e-mail by mistake and delete this e-mail from your system. _______________________________________________ freebsd-questions@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"
