Dear all,
The idea is to share it over a local area network.
This LAN has a wins server.
my server has a jail in which samba resides.
In order for the LAN to be serviced by my jailed samba I have NATED and
RDRed the required packets
In order for the LAN to browse the network NETBIOS seems to be a problem.
AFAIK when one sends a netBIOS packet an ip is embedded and the response is
sent to that ip. NAT only redirects the packet to he appropriate network,
but apparently the packet needs to be altered too in order for a response to
be sent.
I hope this information was sufficient
<snip>
smb_jail_ip="10.0.0.3"
int_ip="172.20.25.177"
samba_UDP_ports = "{netbios-ns, netbios-dgm}"
samba_TCP_ports = "{microsoft-ds, netbios-ssn}"
#smb
nat on $int_if from $smb_jail_ip to $int_if:network ->$int_ip
rdr on $int_if proto TCP from any to $int_ip port $samba_TCP_ports ->
$smb_jail_ip
rdr on $int_if proto UDP from any to $int_if:broadcast port $samba_UDP_ports
-> $smb_jail_ip
rdr on $int_if proto UDP from any to $int_ip port $samba_UDP_ports ->
$smb_jail_ip
pass in quick on $int_if all
pass out quick on $int_if all
</snip>
On 7/5/07, Norberto Meijome <[EMAIL PROTECTED]> wrote:
On Wed, 4 Jul 2007 19:22:13 +0200
"Gabor Tjong A Hung" <[EMAIL PROTECTED]> wrote:
> Dear all,
>
> I was told that my questions was better served here than in ports@
>
>
> > I've recently put my samba server in a jail, but as you can see @
> > http://www.faughnan.com/netbios.html NetBIOS is a bit of a problem and
can
> > cause alot of headache. I was unable to find a nat helper for pf, so I
was
> > wondering if I could bridge my jail with it's host. the bridge
> > manual<http://www.freebsd.org/cgi/man.cgi?query=bridge&sektion=4
>however
> > requires me to have *two* network devices(or so it says), but my
> > jails are just aliases on the same network device.
> > Does anyone know another solution to make browsing possible? or have a
> clue
> > on how to make the solutions I tried work.
> >
> > >ifconfig
> > rl0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
> > options=8<VLAN_MTU>
> > inet6 fe80::202:44ff:fe30:dd04%rl0 prefixlen 64 scopeid 0x1
> > inet 172.20.25.177 netmask 0xfffffc00 broadcast 172.20.27.255
> > inet 10.0.0.3 netmask 0xffffffff broadcast 10.0.0.3
> > inet 10.0.0.2 netmask 0xffffffff broadcast 10.0.0.2
> > inet 10.0.0.6 netmask 0xffffffff broadcast 10.0.0.6
> > inet 10.0.0.4 netmask 0xffffffff broadcast 10.0.0.4
> > inet 10.0.0.5 netmask 0xffffffff broadcast 10.0.0.5
> > ether 00:02:44:30:dd:04
> > media: Ethernet autoselect (100baseTX <full-duplex>)
> > status: active
hi Gabor,
are you trying to share over SMB between the jails?
between the hosts and the jails?
you may want to explain your plans... using NAT for netbios seems a bit
overkill to me, unless you plan to send SMB packets over the larger
internet...which in itself seems a bad idea.
If you only need SMB across different LAN segments, setup WINS server(s)
(MS or
from the Samba project).
B
_________________________
{Beto|Norberto|Numard} Meijome
"It is a lesson which all history teaches wise men, to put trust in ideas,
and
not in circumstances." Emerson
I speak for myself, not my employer. Contents may be hot. Slippery when
wet.
Reading disclaimers makes you go blind. Writing them is worse. You have
been
Warned.
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
