At 09:00 AM 11/14/2007, Barnaby Scott wrote:
I suspect I already know the answer to this, which is that the trouble I am having is nothing to do with the OS at all, but I have to ask, because I am otherwise up against a total brick wall!

I bought a second-hand Dell Poweredge 4600 and installed FreeBSD 6.2 earlier this year. I had it set up with RAID5 using its PERC3/DC controller, with 7 x 73GB disks (+ 1 hot spare). So far so good, and it worked faultlessly as a Samba server for several months.

At the beginning of October, it went down, reporting a mismatch between the configuration on the NVRAM and the disks. With help from Dell support, I managed to recreate the RAID array and it worked again for a month.

In early November it happened again, and has kept happening since. At one point it appeared that the backplane was faulty, so I replaced that, but I cannot keep the server up for more than a day or so without this 'mismatch' poblem.

What about diagnostics on the hardware you may ask? I have run all the diagnostic tools that Dell can supply - several times - and the server declares itself to be totally fault-free.

My specific questions therefore:

Is there any way at all that FreeBSD could be invloved with this problem? (I did notice for example that the Dell PERC3/DC controller was not in the list of supported hardware - but then again, why did it work for several months?)

Can I use FreeBSD to tell me anything about the fault that Dell's diagnostic tools haven't found?

(I do hope someone might be able to help - Dell are trying to get me to switch to a 'supported' OS!)


Thanks

Barnaby Scott

It doesn't sound like any OS issue as you set up the RAID outside the OS. It may be a bad drive or drive(s). Most RAID drives have RAID information written to the drives, and if this becomes unreadable you will have RAID faults.

Another likely culprit is heat. Overheating drives often fail. Are you sure the temperatures in the drive enclosure is OK?

If you can, run diagnostics on the drives, this usually requires running these with the drives taken out of the RAID array though.

        -Derek

--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
MailScanner thanks transtec Computers for their support.

_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"

Reply via email to