thanks....
i did install the system now on ar0. the dmesg output below didn't
change. the df does show only one drive - ar0 - with a few slices...
assuming now that i have RAID1 working is there any way to monitor disks
individually? or as an array?
how can i be sure that the RAID is actually working? or get any stats?
i figured the driver for the <Intel MatrixRAID RAID1> must be iir. bit
from the iir man page ther is not much about monitoring or status...
thanks...
Tamouh H. wrote:
hi ...
i have a simple RAID question(s).
this is from the dmesg of a newly installed bsd7:
ad4: 238475MB <Seagate ST3250310AS 3.AAA> at ata2-master SATA150
ad6: 238475MB <Seagate ST3250310AS 3.AAA> at ata3-master SATA150
ar0: 238472MB <Intel MatrixRAID RAID1> status: READY
ar0: disk0 READY (master) using ad4 at ata2-master
ar0: disk1 READY (mirror) using ad6 at ata3-master
from what i understand here is that if at the time of
installation i install the system on ar0 that means i'd have
RAID1 made out of ad4 and ad6.
right?
is there any configuration to be done?
how do i know what driver is being used? it says:
hptrr: HPT RocketRAID controller driver v1.1 (Feb 24 2008
19:59:27) .............................................
hptrr: no controller detected.'
that's it. thanks.
It is saying "ar0: 238472MB <Intel MatrixRAID RAID1> status: READY"
So assume it is onboard Intel RAID. When configuring FBSD setup, just make sure
you're selecting the ar0 controller and partition it as you like. That is it!
Tamouh
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
