Dear Bruce
Thank you for a prompt response.
The command you give will set the two ends of the GIF connection and we
are using it, but it is not the command that sets the physical ends of
the tunnel.
We would expect something of the form
gifconfig_gif0="fec0::1 fec0::2"
but there appears to be no ipv6 form
Regards
Malcolm
Bruce Cran wrote:
Malcolm Clarke wrote:
We are trying to configure an IPv6 tunnel for IPSec, ie IPv6 in IPv6.
The command line would be
ifconfig gif0 inet6 tunnel src-addr dst_addr (IPv6 addresses)
There appears to be no equivalent line for rc.conf.
Regards
Malcolm
To configure an if_gif interface for IPv6 use:
ipv6_ifconfig_gif0="src-addr dst_addr"
--
Bruce
--
---------------------------------------------------
Dr Malcolm Clarke
Senior Lecturer in Data Communication Systems and Telemedicine
Department of Information Systems and Computing
Brunel University
Uxbridge
Middlesex
UB8 3PH
UK
Tel: +44 1895 265053
Fax: +44 1895 251686
http://www.brunel.ac.uk/about/acad/siscm/research/themes/is/groups/bright/people
----------------------------------------------------
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
