Hello. I am trying to get an AboveCable (model: ACPC 2000-01) wireless card connected to my home network with 40-bit Hex WEP Encryption on FreeBSD 6.1.
# ifconfig wi0 inet 192.168.1.90 ssid ZWW wepmode on wepkey 0xea82552825 ifconfig: SIOCS80211: Invalid argument Did I made anything wrong or miss something in the kernel? I have the related lines in kernel: driver wi driver wlan AboveCable wireless card uses PRIMSA II which is supported by driver wi. The same card is tested working fine on the same network on Ubuntu Linux (without needing of firmware or NDIS Wrapper) dmesg is attached. # ifconfig -a plip0: flags=108810<POINTOPOINT,SIMPLEX,MULTICAST,NEEDSGIANT> mtu 1500 lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 16384 inet6 ::1 prefixlen 128 inet6 fe80::1%lo0 prefixlen 64 scopeid 0x2 inet 127.0.0.1 netmask 0xff000000 wi0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500 inet6 fe80::260:b3ff:fe73:3f4f%wi0 prefixlen 64 scopeid 0x3 ether 00:60:b3:73:3f:4f media: IEEE 802.11 Wireless Ethernet autoselect (DS/2Mbps) status: no carrier ssid ZWW channel 1 stationname "FreeBSD WaveLAN/IEEE node" authmode OPEN privacy ON deftxkey 1 txpowmax 100 bintval 100
Copyright (c) 1992-2006 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. FreeBSD 6.1-RELEASE #0: Thu Jul 5 12:26:43 CST 2007 [EMAIL PROTECTED]:/usr/obj/usr/src/sys/QUASIMODO Timecounter "i8254" frequency 1193182 Hz quality 0 CPU: Pentium/P55C (quarter-micron) (232.11-MHz 586-class CPU) Origin = "GenuineIntel" Id = 0x581 Stepping = 1 Features=0x8001bf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8,MMX> real memory = 100466688 (95 MB) avail memory = 88723456 (84 MB) Intel Pentium detected, installing workaround for F00F bug kbd1 at kbdmux0 cpu0 on motherboard pcib0: <Host to PCI bridge> pcibus 0 on motherboard pir0: <PCI Interrupt Routing Table: 4 Entries> on motherboard pci0: <PCI bus> on pcib0 cbb0: <TI1250 PCI-CardBus Bridge> mem 0x20822000-0x20822fff at device 2.0 on pci0 pccard0: <16-bit PCCard bus> on cbb0 cbb1: <TI1250 PCI-CardBus Bridge> mem 0x20821000-0x20821fff at device 2.1 on pci0 pccard1: <16-bit PCCard bus> on cbb1 pci0: <display, VGA> at device 3.0 (no driver attached) isab0: <PCI-ISA bridge> at device 6.0 on pci0 isa0: <ISA bus> on isab0 atapci0: <Intel PIIX4 UDMA33 controller> port 0x1f0-0x1f7,0x3f6,0x170-0x177,0x376,0xfcf0-0xfcff at device 6.1 on pci0 ata0: <ATA channel 0> on atapci0 ata1: <ATA channel 1> on atapci0 uhci0: <Intel 82371AB/EB (PIIX4) USB controller> port 0x9000-0x901f irq 11 at device 6.2 on pci0 uhci0: [GIANT-LOCKED] usb0: <Intel 82371AB/EB (PIIX4) USB controller> on uhci0 usb0: USB revision 1.0 uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub0: 2 ports with 2 removable, self powered pci0: <bridge> at device 6.3 (no driver attached) pmtimer0 on isa0 orm0: <ISA Option ROM> at iomem 0xc0000-0xc9fff on isa0 atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0 atkbd0: <AT Keyboard> irq 1 on atkbdc0 kbd0 at atkbd0 atkbd0: [GIANT-LOCKED] psm0: <PS/2 Mouse> irq 12 on atkbdc0 psm0: [GIANT-LOCKED] psm0: model Generic PS/2 mouse, device ID 0 fdc0: <Enhanced floppy controller> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0 fdc0: [FAST] fd0: <1440-KB 3.5" drive> on fdc0 drive 0 ppc0: <Parallel port> at port 0x3bc-0x3c3 irq 7 on isa0 ppc0: Generic chipset (NIBBLE-only) in COMPATIBLE mode ppbus0: <Parallel port bus> on ppc0 plip0: <PLIP network interface> on ppbus0 lpt0: <Printer> on ppbus0 lpt0: Interrupt-driven port ppi0: <Parallel I/O> on ppbus0 sc0: <System console> at flags 0x100 on isa0 sc0: VGA <16 virtual consoles, flags=0x300> sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0 sio0: type 16550A sio1: configured irq 3 not in bitmap of probed irqs 0 sio1: port may not be enabled sio2: configured irq 5 not in bitmap of probed irqs 0 sio2: port may not be enabled sio3: configured irq 9 not in bitmap of probed irqs 0 sio3: port may not be enabled vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0 unknown: <PNP0303> can't assign resources (port) unknown: <PNP0f13> can't assign resources (irq) unknown: <PNP0700> can't assign resources (port) unknown: <PNP0c02> can't assign resources (memory) unknown: <PNP0400> can't assign resources (port) pcm0: <CS423x> at port 0x530-0x537,0x388-0x38b,0x220-0x233 irq 5 drq 1,0 on isa0 pcm0: [GIANT-LOCKED] unknown: <IBM0071> can't assign resources (port) unknown: <PNP0e03> can't assign resources (port) Timecounter "TSC" frequency 232106515 Hz quality 800 Timecounters tick every 1.000 msec wi0: <AboveCable ACPC2000-11> at port 0x100-0x13f irq 10 function 0 config 1 on pccard1 wi0: using RF:PRISM2 MAC:HFA3841 CARD:HWB3163 rev.A wi0: Intersil Firmware: Primary (0.3.0), Station (0.8.3) wi0: Ethernet address: 00:60:b3:73:3f:4f ad0: 3102MB <IBM DTCA-23240 TC5OAB1A> at ata0-master UDMA33 acd0: CDROM <SANYO CRD-S372B/1.24F> at ata0-slave PIO3 Trying to mount root from ufs:/dev/ad0s1a WARNING: / was not properly dismounted umass0: Generic Mass Storage, rev 2.00/1.01, addr 2 umass0: Get Max Lun not supported (STALLED) da0 at umass-sim0 bus 0 target 0 lun 0 da0: <Generic Flash Disk 8.07> Removable Direct Access SCSI-2 device da0: 1.000MB/s transfers da0: 4022MB (8238080 512 byte sectors: 255H 63S/T 512C) WARNING: /usr was not properly dismounted WARNING: /var was not properly dismounted ext2fs: da0: wrong magic number 0 (expected 0xef53) Interrupt storm detected on "irq11:"; throttling interrupt source ieee80211_load_module: load the wlan_wep module by hand for now. ieee80211_load_module: load the wlan_wep module by hand for now. ieee80211_load_module: load the wlan_wep module by hand for now. ieee80211_load_module: load the wlan_wep module by hand for now. ieee80211_load_module: load the wlan_wep module by hand for now. ieee80211_load_module: load the wlan_wep module by hand for now. ieee80211_load_module: load the wlan_wep module by hand for now. ieee80211_load_module: load the wlan_wep module by hand for now. ieee80211_load_module: load the wlan_wep module by hand for now. umass0: at uhub0 port 1 (addr 2) disconnected (da0:umass-sim0:0:0:0): lost device (da0:umass-sim0:0:0:0): removing device entry umass0: detached umass0: Generic Flash Disk, rev 1.10/1.00, addr 2 da0 at umass-sim0 bus 0 target 0 lun 0 da0: <Generic USB Flash Drive %z!Y> Removable Direct Access SCSI-2 device da0: 1.000MB/s transfers da0: 124MB (254720 512 byte sectors: 64H 32S/T 124C)
_______________________________________________ freebsd-questions@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"