The pciconf -l line for the controller would be useful. Some other debug
data may be useful too, but I'll need to review some code first before I
know what more I need.
--
Justin
Jay Hall wrote:
That worked. Would any of the information displayed while booting be
helpful at this point?
Jay
On Jul 7, 2009, at 10:46 AM, Justin T. Gibbs wrote:
Go into the card 29320's BIOS and configure your tape drive for
non-packetized
negotiation. If this works, we can try a few other things in the
driver to see
if it is possible to get things working in packetized mode.
--
Justin
Jay Hall wrote:
I just installed an Adaptec 29320ALP-R in my FreeBSD 7.2 server.
Connected to the card is an HP Ultrium 1/8 G2 tape drive.
During the boot sequence, FreeBSD pauses to wait for the SCSI devices
to settle. Then, I receive the following message
(probe79:ahd0:0:4:0: Probable outgoing LQ CRC error. Retrying command.
I have moved the card to a different slot with the same results,
replaced the cable, etc. If I do not power on the tape drive, the
system will boot normally.
Any suggestions would be greatly appreciated.
Thanks,
Jay
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to
"freebsd-questions-unsubscr...@freebsd.org"
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "freebsd-questions-unsubscr...@freebsd.org"
