Jason, I'll try again tomorrow. I think the board is bad, to be completely honest.
I pulled my desktop board out and installed that, got 8.0 to install OK there, then went to attach the RAID card (an HPT RocketRaid) and boom. It loads the BIOS, loads the RAID BIOS and nothing. I'll try again tomorrow. Thanks for the lead. -- Ryan On Jan 4, 2010, at 7:38 PM, Jason wrote: > I worked with a similar patch for the bce driver, and received the same > issue. > > From what I've seen, the patch would be for the "mii" device for this error. > > After patching mii, the error and issues were resolved. > > On Mon, Jan 04, 2010 at 06:28:36PM -0600, Ryan Coleman thus spake: >> I have a RealTek 816x NIC in my FreeBSD 8.0 box. I did a full system install >> last night and at 2AM the NIC gave out. Now it's crapping out in minutes >> instead of hours. >> >> When I run /etc/rc.d/netif restart I get the normal processing data about >> my NICs and then this: >> re0: reset never completed! >> re0: PHY write failed >> re0: PHY write failed >> re0: PHY write failed >> re0: PHY write failed >> re0: PHY write failed >> >> And it proceeds to bring lo0 and re0 back up, but re0 has it's listed static >> IP but is not discoverable on the network. >> >> A reboot can temporarily fix this but I want to avoid rebooting every 4-6 >> hours automatically (for obvious reasons). >> >> I've found patches referencing 7.1 but not 8.0. >> >> I can post more details if you need, just point me where you need me to look >> for them. >> >> -- >> Ryan >> _______________________________________________ >> freebsd-questions@freebsd.org mailing list >> http://lists.freebsd.org/mailman/listinfo/freebsd-questions >> To unsubscribe, send any mail to "freebsd-questions-unsubscr...@freebsd.org" >> _______________________________________________ freebsd-questions@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "freebsd-questions-unsubscr...@freebsd.org"
