Lowell, Per my earlier episle. When the FD is removed from activation the result is the same. FWIW there are only 2 invaguaries. These relate to the VIATech (1106) power Management Controller (3040) and the Createive Technology (1274) Ensoniq ESB71 (1371). After the: uhub0: 2 ports with 2 removable, self powered output during boot, I get: pci0: <unknown card> (vendor=0x1106, dev=0x3040) at 7.3 pci0: <unknown card> (vendor=0x1274, dev=0x1371) at 10.0 irq 9 this is followed by the recognition of the ethernet cards and the last 2 statements are: pcib1: <Host to PCI bridge> on motherboard pci2: <PCI bus> on pcib1 followed, as I said, by a hung system. I included the above only because I am not 100% certain that it has no relavence to the hung system. I have not installed FreeBSD before but have used Slackware Linux for 10+ years.
Lowell Gilbert wrote: > Ron Riese <[EMAIL PROTECTED]> writes: > > > Got Freebsd 4.8 disk from cheapbytes. When I install I go through > > driver selection in "Kernel Configuration Menu" and adjusted all but > > address for floppy drive which is 03F0. It cannot be changed. All of > > my systems (win) show this as 03F2. Even tried to eliminate the driver > > entirely. Same result. Tried on my amd k6/2 and Pentium 200 MHz > > platform with same result. Tried OpenBSD and it hangs too after it > > displays its "automatic" (I guess) configuration. Can't determine how > > to narrow the problem to disk or my hardware. Any help appreciated. > > Does it have a problem without adjusting the parameters at all? > Can you install with the floppy disconnected? > > _______________________________________________ > [EMAIL PROTECTED] mailing list > http://lists.freebsd.org/mailman/listinfo/freebsd-questions > To unsubscribe, send any mail to "[EMAIL PROTECTED]" _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"