Neither mouse will work in the console or in XFree86. Gigabyte GA-6BXDS = main board BIOS= AWARD (2A69KG01) ver. 4.51PG
In the PCI/ISA section of the BIOS, a USB setting of: "Assign IRQ For USB: Enabled" (is set) There is also a "USB Keyboard Support" setting within the BIOS's "INTERGRATED PEROPHERALS" section; I have tried this setting to both "Enabled and Disabled". There aren't any other USB settings in this BIOS. We are using these devices that are known working devices. Mouse-1 is: Logitech | model: M-BD58 | optical corded wheel Mouse-2 is: Logitech | model: M-RM67A | Optical cordless wheel Our Kernel: # USB support device uhci # UHCI PCI->USB interface device usb # USB Bus (required) device ums # Mouse pseudo-device ether # Ethernet support Our /etc/rc.conf: # grep -i mouse /etc/rc.conf moused_enable="YES" moused_port="/dev/ums0" # grep -i usb /etc/rc.conf usbd_enable="YES" Our /dev: ls -l /dev | grep -i ums crw-rw---- 1 root operator 111, 0 Sep 27 13:16 ums0 dmesg reports: # dmesg | grep -i usb uhci0: <Intel 82371AB/EB (PIIX4) USB controller> port 0xa000-0xa01f irq 10 at device 7.2 on pci0 usb0: <Intel 82371AB/EB (PIIX4) USB controller> on uhci0 usb0: USB revision 1.0 ums0: Logitech USB Mouse, rev 1.10/6.10, addr 2, iclass 3/1 Upon booting into the OS, using the above BIOS, and other settings --with either of the above devices; the mouse is seen on screen, but it refuse to respond while moving the hand-held device. Should we unplug one mouse (from either usb port) to test the other mouse, we receive the following on-screen message(s), respectively of the motherboards USB port we were using: uhub0: device problem, disabling port 2 uhub0: device problem, disabling port 1 When we plug the devices back in to either of the motherboards mouse ports, there's no indication at all, from the OS, that a USB device was attached. Reminder: these devices are in perfect working order. _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"