Lowell Gilbert <[EMAIL PROTECTED]> wrote:
"toor" <[EMAIL PROTECTED]> writes:
On 21 Nov 2003 09:06:31 -0500
Lowell Gilbert <[EMAIL PROTECTED]> wrote:
>"toor" <[EMAIL PROTECTED]> writes:
>
>> When I begin setup I see next message:
>> eisa0: <EISA bus> on motherboard
>> eisa0: unknown card [EMAIL PROTECTED] (0x08080000) at slot 1
>> Fatal trap 9: general protection fault while in kernel mode
>> instruction pointer = 0x58:0x81d1
>> stack pointer = 0x10:0xeb8
>> frame pointer = 0x10:0xf0e
>> code segment = base 0xc00f0000, limit 0xffff, type 0x1b
>> = DPL 0, pres 1, def32 0, gran 0
>> processor elfags = interrupt enabled, resume, IOPL = 0
>> current process = 0 (swapper)
>> trap number = 9
>> panic: general protectin fault
>> What must I do to setup freeBSD to my notebook.
>
>Do you need 5.1?
>http://www.freebsd.org/releases/5.1R/early-adopter.html
You mean that I must install FreeBSD ver 4.9 RELEASE???
I don't mean that at all. Just that you should be aware that FreeBSD
5.x is not intended for production use at this time.
I install FreeBSD 5.1 RELEASE, I patch pnpbios function in bios.c and bild kernel. When I can boot and install to my notebook. As it proved, boot image from CDROM/floppies/boot.flp content bad kernel or mfsroot, because when I install and reboot - FreeBSD 5.1 RELEASE will load successfully:).
_______________________________________________
[EMAIL PROTECTED] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
