On Wed, 17 Dec 2003 14:36:21 -0000 "Admin" <[EMAIL PROTECTED]> wrote:
> Dear sir/ madam, Please warp. > The FreeBSD 5.1 PowerPak was purchased from FreeBSD Mall Ref Invoice > No: 3120119. This package has been ordered to develop a FreeBSD Driver > for PCI Bus Interface. When tried installing, on Pentium P4 2.53GHz, > the installation fails during installing the package on to the hard > disc, displaying message e.g. Extracting base into / dir, Panic > ufs_dirbad: bad dir and ask to reboot the system. After several > attempts, I have managed to install the minimum installation. Please post the output of dmesg and your hardawe. We can say anything without knowing your hardware. > I have tried installing on a Pentium Pro 300MHz PC and it won't let me > configure the X. Both proc fully supported. > When I try to configure the X, the system starts > rebooting. Would you kindly advise, what should I do? Did you make any world /kernel build & install ? Try configuring using xf86config instead of xf86cfg. Give more details. > I have very tight requirement. I need to develop the driver and supply > to the customer by end of January 2004. Good luck. > Is this software fully installable? Yes. It sould. I'm running it ;) > If not, would you please send me the updated software a.s.a.p. > > Would you please advise a.s.a.p. Note that you are posting to a comunity mailling list. Also note that The Freebsd Project and The FreeBSD Foundation is not responsable for FreeBSD Mall which is a third party. Also note that I'm not speaking for either of them. -- IOnut Unregistered ;) FreeBSD user _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"
