[EMAIL PROTECTED] writes: > Hello, > > I had 4.9 release working and did a clean install of 5.1 release over > the 4.9 and ended up with boot failure after install. Using allBSD > partition and standard MBR I get a missing operating system error. If I > use the FreeBSD boot I just get "default F1" and a beep. Now trying to > install the 4.9 gives the same results. > > I'm using a Mylex DAC960ptl (accelraid 250) with the primary disk > setup as JBOD. I set the bootable disk as active but everytime I go > back to config fdisk the flag is not set. > > I then upgraded and flashed the RAID card, reformatted the disks and > tried a 4.9 install, again with the same results. > > Is there an issue with the DAC card geometry or BIOS? Or a subtle > quirk that isn't documented yet?
Sounds more like you're not using the option to actually write out the results to disk. (W)rite, maybe? _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"