> Well can u just tell me you fixed which drive on which bus and did u > configure them master-slave specifically or did u go with CS?
I have LG CD-writer as master and the Asus DVD writer as slave on the second ATA channel, both configured specifically with jumpers. I also tried disconnecting the CD-Writer and leaving the DVD writer alone as a master on the bus. I can also add that they are interfaced with 80- -pin cable, and the LG CD-Writer writes the same CDs and CD-RWs well. > I don't > believe that the DVD Writer is not ATAPI compatible. I find that strange too :) > There is some > configuration glitch somewhere. i wish the other DVD writer I had (i returned it and bough the Asus one instead, coz it was junk), although it was broken, could write a CD with 'burncd', then, while trying to fixate it (on very high speed!) it failed or just halted. > Btw I hope u r using 4.9-stable? tested on 4.6.2-RELEASE and freshly installed 4.9-RELEASE > -----Original Message----- > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] > Sent: Sunday, January 04, 2004 1:47 PM > To: [EMAIL PROTECTED] > Cc: [EMAIL PROTECTED] > Subject: Re: writing CD-RWs with DVD?RW and burncd > > > Yes it is very much possible. Just go around as if it is a CD Writer and > > not a DVD writer. > > so that means that my DVD writer is not ATAPI compatible? or am I doing > something wrong? > > > -----Original Message----- > > is it possible to write CDs with a DVD writer on -STABLE usind 'burncd'? > > > > --- > > bash-2.05a# burncd -f/dev/acd1c -s4 blank data > > /tmp/frenzy_v02_release.iso fixate > > blanking CD - 100 % done > > next writeable LBA 0 > > writing from file /tmp/frenzy_v02_release.iso size 196832 KB > > written this track 832 KB (0%) total 832 KB > > only wrote -1 of 32768 bytes err=16 > > > > fixating CD, please wait.. > > --- > > no kern.* messages > > > > Is it because my DVD+-RW is not ATAPI CD-RW compatible? Everything works > > well with 'cdrecord'. > > > > acd1: <ASUS DRW-0402P/D/1.05> DVD-R drive at ata1 as slave > > acd1: read 5511KB/s (3021KB/s) write 688KB/s (688KB/s), 2000KB buffer, > > PIO4 > > > acd1: Reads: CD-R, CD-RW, CD-DA stream, DVD-ROM, DVD-R, packet > > acd1: Writes: CD-R, CD-RW, DVD-R, test write, burnproof > > acd1: Audio: play, 256 volume levels > > acd1: Mechanism: ejectable tray, unlocked > > acd1: Medium: CD-RW 120mm data disc > > acd0: success setting WDMA2 on Intel chip > > acd1: success setting UDMA2 on Intel chip Timestamp: 1073208443 [SorAlx] http://cydem.org.ua/ _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"
