did you enter the command use.perl port
after installing perl 5.8 _before_ rebuilding rt3 ?? Perl by default will continue to use the perl supplied with the initial site distro... to switch back it use.perl site mjt On Fri, 2004-05-21 at 13:51, Shawn Guillemette wrote: > I needed to install something better then perl 5.6.1 in order to install > something from another port. So I did a locate on perl and > found /usr/ports/lang/perl5.8 So I cd to the dir and make install and after > it completed with no errors the I go back to the port I was attempting to > install and I get the same message: > > rt3-3.0.9 This program only support perl 5.6.1 or above. > > Unfortunately I dont know what version I has using before. I was wondering if > there was somthign I needed to do to stop using the older version and start > using the new one? > > > -- > Shawn Guillemette > > _______________________________________________ > [EMAIL PROTECTED] mailing list > http://lists.freebsd.org/mailman/listinfo/freebsd-questions > To unsubscribe, send any mail to "[EMAIL PROTECTED]" > > ************************************************************************ > This Email has been scanned for Viruses by MailMarshal. > ************************************************************************ -- Murray Taylor Special Projects Engineer --------------------------------- Bytecraft Systems & Entertainment P: +61 3 8710 2555 F: +61 3 8710 2599 D: +61 3 9238 4275 M: +61 417 319 256 E: [EMAIL PROTECTED] or visit us on the web http://www.bytecraftsystems.com http://www.bytecraftentertainment.com ************************************************************************ This Email has been scanned for Viruses by MailMarshal. ************************************************************************ _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"