You need to kill all the running dhclient processes, then try again. Usually, this can be done with:
#killall -9 dhclient HTH Eric F Crist President AdTech Integrated Systems, Inc (612) 998-3588 > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of > [EMAIL PROTECTED] > Sent: Saturday, June 05, 2004 11:29 AM > To: [EMAIL PROTECTED] > Subject: routing question > > > I am trying to configure a wireless router so I am redefining > routes and IP address of my system. After booting dhclient > ep0 works fine. After messing around with the wireless router > I was just going back to my ethernet connection so I did: > > ifconfig ep0 192.168.0.3 remove > arp -da > route flush > dhclient ep0 > > This returned immediatly without assigning an IP or route so > I just connected manually using ifconfig and route. There > must be something I did not clear out, but I can not figure > it out. Thanks for any ideas. This is on 4.10 if that makes > any difference. > > _____ > Douglas Denault > http://www.safeport.com > [EMAIL PROTECTED] > Voice: 301-469-8766 > Fax: 301-469-0601 _______________________________________________ > [EMAIL PROTECTED] mailing list > http://lists.freebsd.org/mailman/listinfo/free> bsd-questions > > To unsubscribe, send any mail to > "[EMAIL PROTECTED]" > _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"
