"Richard Lynch" <[EMAIL PROTECTED]> wrote: > Christophe Asselin wrote: > > I want to install FreeBsd 5.2.1 but when i boot from the install i386 cd > > an error occur. > > > > Some text appear and it froze (stuck at these lines) > > "pcibo:<acpi host-pci bridge> port oxcf8-oxcff on acpi0 > > pci0:<acpi pci bus> on pcibo > > pcibo: slot 2 INTA is routed to irq 10" > > > > in windowsxp, if I watch for irq10, it say that my intel 82852/82855 > > GM/GME graphic card is on that irq > > IRQs are shared, so there could be TWO things on IRQ 10... > > So you can't really be sure it's your graphic card. > > I believe that is the same card as is in my laptop, and 5.2.1 installed > fine on that... > > I'm not saying for sure it's *NOT* your graphics card -- just that it's > not looking all that likely... > > Cheap/easy things to try: > re-download (or check the checksum) the disk 1 binary. > re-burn a new CDR.
Additionally, grab one of the 5.3BETA snapshots and try it out. A LOT of things have been fixed/improved since 5.2.1. -- Bill Moran Potential Technologies http://www.potentialtech.com _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"
