On Thu, 4 Nov 2004, Nelis Lamprecht wrote:
On Thu, 4 Nov 2004 14:10:42 +0100 (CET), Are Bryne <[EMAIL PROTECTED]> wrote:[...]
After upgrading a computer from FreeBSD 4.8-something to 4.10-RELEASE-p3, I'm getting lots of the following:
ad0: WRITE command timeout tag=0 serv=0 - resetting ata0: resetting devices .. done
The disk in question is a
FUJITSU MPC3043AT/6018 using ATA/ATAPI rev 3 according to atacontrol.
It is master on its controller and uses UDMA33 transfers, and has an idle PIO4 cd-rom player as a slave.
The controller is identified in dmesg as:
atapci0: <VIA 82C586 ATA33 controller> port 0xe000-0xe00f at device 7.1 on pci0
[...]
Hi,
Seen this once before and in my case it was a faulty hard drive cable. Check to see whether your cable is not loose or incorrectly inserted and perhaps try a new one.
Thank you - I will check that.
It may also be caused by an incorrect DMA setting if memory serves me correct.
I might try turning DMA off to see if that helps...
Nelis
Again, please CC me to make sure I see the whole thread.
Regards, Are Bryne -- Communiqué DA Office: +47 22 44 33 99 Postboks 9050 Grønland Mobile: +47 900 22 009 NO-0133 Oslo URL: http://www.communique.no
_______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"