I'm trying to get FreeBSD to "see" my iPod filesystem. I stumbled across this howto, http://www.osxhax.com/archives/000009.html, that outlines the procedure when using firewire.
Unfortunately, my board doesn't support fireware, and so I have to use USB. The iPod is detected at boot, as can be seen in the log: * This section takes a long time to complete * (probe0:umass-sim0:0:0:0): Request completed with CAM_REQ_CMP_ERR (probe0:umass-sim0:0:0:0): Retrying Command (probe0:umass-sim0:0:0:0): Request completed with CAM_REQ_CMP_ERR (probe0:umass-sim0:0:0:0): Retrying Command (probe0:umass-sim0:0:0:0): Request completed with CAM_REQ_CMP_ERR (probe0:umass-sim0:0:0:0): Retrying Command * End of section * GEOM: new disk da0 ioapic0: routing intpin 1 (ISA IRQ 1) to cluster 0 ioapic0: routing intpin 3 (ISA IRQ 3) to cluster 0 ioapic0: routing intpin 4 (ISA IRQ 4) to cluster 0 ioapic0: routing intpin 6 (ISA IRQ 6) to cluster 0 ioapic0: routing intpin 7 (ISA IRQ 7) to cluster 0 ioapic0: routing intpin 8 (ISA IRQ 8) to cluster 0 ioapic0: routing intpin 9 (ISA IRQ 9) to cluster 0 ioapic0: routing intpin 13 (ISA IRQ 13) to cluster 0 ioapic0: routing intpin 14 (ISA IRQ 14) to cluster 0 ioapic0: routing intpin 15 (ISA IRQ 15) to cluster 0 ioapic0: routing intpin 16 (PCI IRQ 16) to cluster 0 ioapic0: routing intpin 18 (PCI IRQ 18) to cluster 0 ioapic0: routing intpin 21 (PCI IRQ 21) to cluster 0 ioapic0: routing intpin 22 (PCI IRQ 22) to cluster 0 da0 at umass-sim0 bus 0 target 0 lun 0 da0: <Apple iPod 1.62> Removable Direct Access SCSI-0 device da0: Serial Number JQ5040KTPS9 da0: 1.000MB/s transfers da0: 19073MB (39063024 512 byte sectors: 255H 63S/T 2431C) The marked section takes several minutes to complete. I thought I'd try mounting da0 as is done in the tutorial, the fstab entry being, /dev/da0 /ipod msdos rw,noauto 0 0 , but it fails with the error message "msdosfs: /dev/da0: Invalid argument." I get no other da0* /dev entries. The boot message for the USB port to which I attached the iPod (which is a USB 2.0 port) might also be helpful, so I'll include it: usb1: OHCI version 1.0, legacy support usb1: SMM does not respond, resetting usb1: <OHCI (generic) USB controller> on ohci1 usb1: USB revision 1.0 does the last line mean FreeBSD isn't correctly detecting USB 2.0 on the port? I'm running FreeBSD 5.3-RELEASE, using a Epox nForce2 motherboard. Help appreciated as always. _______________________________________________ freebsd-questions@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"
