On Apr 25, 2011 6:28 AM, "Ian Smith" <smi...@nimnet.asn.au> wrote: > > On Mon, 25 Apr 2011, Bartosz Fabianowski wrote: > [Jeremy wrote:] > > > As the processor gets hotter, internal clocks and so on are throttled > > > within the hardware to try and stabilise the temperature (to keep the > > > thermal trip point being reached, re: "emergency shutdown"), which > > > greatly decreases performance. I'm not sure if there's a way to > > > detect this, but I would hope (?) that it would be visible via the > > > CPU clock frequency (on FreeBSD this would be sysctl > > > dev.cpu.X.freq). > > > > sysctl dev.cpu.X.freq is used to set the frequency. I have not found any > > way to read back its internal state so far. > > dev.cpu.X.freq does reflect the current frequency; I don't know whether > or how any internal clock throttling might be exposed. > > Jeremy's right, it's running very hot, probably 20C too hot. I was just > going to mention a couple of things you could try when it began to seem > all too familiar .. a bit of hunting found your previous overheating > problems on a Dell Studio 1557 from April last year: > > http://lists.freebsd.org/pipermail/freebsd-acpi/2010-April/006415.html > > and your eventual apparent solution which included some fiddling with > thermal parameters but primarily by disabling p4tcc and acpi_throttle > > hint.p4tcc.0.disabled="1" > hint.acpi_throttle.0.disabled="1" > > in loader.conf; I'm surprised you haven't tried that again on this one? > > > hw.acpi.cpu.cx_lowest: C1 > > See below. > > > hw.acpi.thermal.min_runtime: 0 > > hw.acpi.thermal.polling_rate: 10 > > hw.acpi.thermal.user_override: 0 > > hw.acpi.thermal.tz0.temperature: 26.8C > > hw.acpi.thermal.tz0.active: -1 > > hw.acpi.thermal.tz0.passive_cooling: 0 > > hw.acpi.thermal.tz0.thermal_flags: 0 > > hw.acpi.thermal.tz0._PSV: -1 > > hw.acpi.thermal.tz0._HOT: -1 > > hw.acpi.thermal.tz0._CRT: 100.0C > > hw.acpi.thermal.tz0._ACx: 71.0C 55.0C -1 -1 -1 -1 -1 -1 -1 -1 > > hw.acpi.thermal.tz0._TC1: -1 > > hw.acpi.thermal.tz0._TC2: -1 > > hw.acpi.thermal.tz0._TSP: -1 > > tz0 looks to be a fan. It seems unlikely that any temp. sensor inside a > machine with CPU temp. at 82C could possibly be as low as 26.8C, so this > value is likely as bogus as the 0.0C CPU reported by tz1.
I am not sure tz0 is the real thermal zone, especially given values of _tc1, _tc2 and _tsp. Temperature value (3001) looks suspicious as well. Can you, by any chance, put your ASL someplace accessible and provide a description of what you have done to fix the temperature reporting. As the side note: I have seen and do own pieces of equipment that use thermal zones to initiate critical shutdown for various and unrelated reasons. _______________________________________________ freebsd-stable@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-stable To unsubscribe, send any mail to "freebsd-stable-unsubscr...@freebsd.org"
