on 17/10/2012 23:51 Derek Kulinski said the following: > On Wed, Oct 17, 2012 at 11:38:57PM +0300, Andriy Gapon wrote: >> I've found that on quite a few modern systems the ACPI platform advertises >> some >> useless thermal zones, which always return some hardcoded temperatures. >> E.g. I have Asus P8Z77-M PRO near me and it also reports two thermal zones. >> Looking at DSDT (acpidump -dt) I see that the temperatures are hardcoded. >> >> It seems that your motherboard has an ITE Super I/O with hardware monitoring >> function. I am not sure which model though... >> Your best bet would be it(4) driver, but it is not committed yet. >> If you are into some mild hacking (applying patches, building custom kernel), >> then I can point you to the patches. >> Although I can not give a firm guarantee that the driver supports your HWM >> chip, >> since I don't know the model. > > I'm open to experimenting. It's kind of important to me, because I recently > had heating issue (that I hopefully fixed) and I wasn't aware of problems > until my system started freezing. I was fooled by those values thinking > everything was ok.
Here is a (quite large) patch: http://people.freebsd.org/~avg/sensors.diff Please note that if affects both kernel and userland code. Read it(4) manual page after upgrading. Note that you will need to add some entries to /boot/device.hints (unless your upgrade procedure would automatically merge the file). >> [...] >> >> These tools from ports are very outdated and thus do not support new >> hardware. > > I never used them before since on my old box hw.acpi.thermal worked fine. > Is there anything in ports that you would recommend? No. I do not know of any good userland tool for recent hardware. -- Andriy Gapon _______________________________________________ freebsd-stable@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-stable To unsubscribe, send any mail to "freebsd-stable-unsubscr...@freebsd.org"