> Under heavy load (I/O load on the disks constantly over 200 tps, average > at about 250 tps, peaks over 600 tps) a random drive disconnects from > the RAID 10. After removing the drive from the config and rescanning the > bus, the drive does not show up anymore. The only way to get the drive > back is to unplug the drive (or switch the computer off, so that power > is removed). After that there is no problem to rebuild the RAID with > the drive. > > -> It's not reproducable. The error occurs under high load, sometimes > three times a week, sometimes it does not happen in 3 months. > > -> It happens only with the Raptors. > > -> It's always a random drive, there's no drive, that disconnects more > often
This sounds like a bug in the drive firmware. Did you look into any firmware updates from Western Digital? It's possible that the 3ware controllers push the drives a bit harder and expose problems that wouldn't show up at slightly lower TPS rates. We (TeraSolutions and Download Technologies) have deployed the 3ware 9500S controllers extensively and haven't seen any problems with the 7k250 and 7k400 series Hitachi drives that we use with them. One of the cool things about the 3ware controllers is that they will automatically do bad block reassignment by first recovering the data from the redundancy, issuing a block reassignment to the drive, and then writing the recovered block back out to the new (reassigned) block. This may seem pretty basic for RAID, but many controllers we've tested actually don't do this. -DG David G. Lawrence President Download Technologies, Inc. - http://www.downloadtech.com - (866) 399 8500 TeraSolutions, Inc. - http://www.terasolutions.com - (888) 346 7175 The FreeBSD Project - http://www.freebsd.org Pave the road of life with opportunities. _______________________________________________ freebsd-stable@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-stable To unsubscribe, send any mail to "[EMAIL PROTECTED]"