On Thu, Aug 17, 2006 at 09:16:43PM -0500, Dan Nelson wrote: > In the last episode (Aug 17), Alan Amesbury said: > > OK, booting *too* quickly is a somewhat unusual problem..... I have > > FreeBSD 6.1-RELEASE-p3 running on a Dell PowerEdge 850. For some > > reason, in the PowerEdge 850 Dell chose to replace the perfectly > > adequate em(4) adapters found on the PE750 with bge(4) hardware. > > FreeBSD identifies these adapters as BCM5750A1, but Dell says they're > > actually Broadcom 5721J adapters instead. See > > > > http://www.dell.com/downloads/global/products/pedge/en/850_specs.pdf > > > > for details. The switch to which the host is connected is a Cisco > > Catalyst 3750. How this relates to FreeBSD, however..... > > Have you enabled portfast on the Cisco? > > http://www.cisco.com/warp/public/473/12.html#c2k > > Another thing to check is whether you have alias IPs. I believe the > bge driver has to reset the card every time you add or remove an IP. > I know the ti driver (whose chipset the broadcom chips are based on) > had that problem. >
If there is a way to program multicasting filters correctly without resettting the hardware there is no need to reset hardware and it could be easily implemented in ether_ioctl(). -- Regards, Pyun YongHyeon _______________________________________________ freebsd-stable@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-stable To unsubscribe, send any mail to "[EMAIL PROTECTED]"