Bezüglich Paul Esson's Nachricht vom 25.04.2018 20:44 (localtime): > Hi Folks, > > I'm struggling with networking when using vm-bhyve on FreeBSD 11.1-RELEASE. I > have two NICs and have configured the first (igb0) on a management network > and want to use the second (igb1) for VMs. However, I can't get any VM to > communicate through the virtual switch if I have igb1 added to it. If I take > the NIC out of the switch and configure an ipv4 address on it I can reach > other hosts on the relevant subnet so I believe the poet set-up is valid. If > I replace igb1 in the switch with igb0, I can then configure VMs on my > management network and they have network connectivity. Can I only use
Hello, a example of the command you used was nice. I guess you're using if_bridge(4) – the example would clarify. But there's ng_bridge(4) and vale(4) also, and others are using OpenVSwitch... > an interface that has an IP address configured at the host level before > adding it to the switch? I've used other No. But the interface has to be in promisc mode. And some offloading functions must be disabled, but in case of if_bridge(4), it's done automagically (and reverted if you remove the interface again). Hth, -harry _______________________________________________ freebsd-virtualization@freebsd.org mailing list https://lists.freebsd.org/mailman/listinfo/freebsd-virtualization To unsubscribe, send any mail to "freebsd-virtualization-unsubscr...@freebsd.org"