Subi o mpd com a seguinte configuração: Trinity# cat mpd.conf default: load pptp0
pptp0: # Create clonable bundle template named B create bundle template B set iface enable proxy-arp set iface idle 1800 set iface enable tcpmssfix set ipcp yes vjcomp # Specify IP address pool for dynamic assigment. set ipcp ranges 172.16.0.1/32 172.16.0.2/24 # set ipcp dns 192.168.1.3 # set ipcp nbns 192.168.1.4 # The five lines below enable Microsoft Point-to-Point encryption # (MPPE) using the ng_mppc(8) netgraph node type. set bundle enable compression set ccp yes mppc set mppc yes e40 set mppc yes e128 set mppc yes stateless # Create clonable link template named L create link template L pptp # Set bundle template to use set link action bundle B # Multilink adds some overhead, but gives full 1500 MTU. set link enable multilink set link yes acfcomp protocomp set link no pap chap set link enable chap # We can use use RADIUS authentication/accounting by including # another config section with label 'radius'. # load radius set link keep-alive 10 60 # We reducing link mtu to avoid GRE packet fragmentation. set link mtu 1460 # Configure PPTP set pptp self 200.143.XXX.YYYY # Allow to accept calls set link enable incoming Erro: [L-1] LCP: SendConfigReq #10 [L-1] ACFCOMP [L-1] PROTOCOMP [L-1] MRU 1500 [L-1] MAGICNUM f657733c [L-1] AUTHPROTO CHAP MSOFTv2 [L-1] MP MRRU 2048 [L-1] MP SHORTSEQ [L-1] ENDPOINTDISC [802.1] 00 1a 64 79 1d c4 [L-1] LCP: parameter negotiation failed [L-1] LCP: state change Req-Sent --> Stopped [L-1] LCP: LayerFinish [L-1] PPTP call terminated [L-1] Link: DOWN event [L-1] LCP: Close event [L-1] LCP: state change Stopped --> Closed [L-1] LCP: Down event [L-1] LCP: state change Closed --> Initial [L-1] Link: SHUTDOWN event [L-1] Link: Shutdown Alguem tem alguma idéia? -----Mensagem original----- De: freebsd-boun...@fug.com.br [mailto:freebsd-boun...@fug.com.br] Em nome de Márcio Luciano Donada Enviada em: segunda-feira, 13 de abril de 2009 18:21 Para: "Lista Brasileira de Discussão sobre FreeBSD (FUG-BR)" Assunto: Re: [FUG-BR] RES: Problema com mpd 3.18 FreeBSD 7.1 Ricardo Augusto de Souza escreveu: > Ok, > > Instalei o 5.2 e agora tenho estes erros: > Label 'startup' not found > mpd.conf:5: Unknown command: 'new -i ng0 pptp0 pptp0'. Try "help". > mpd.conf:6: Incorrect context for: 'set bundle disable multilink' > mpd.conf:7: Incorrect context for: 'set ipcp ranges 172.16.0.1/32 > 172.16.0.2/24' > mpd.conf:8: Incorrect context for: 'set iface enable proxy-arp' > mpd.conf:9: Incorrect context for: 'set iface route 172.16.0.1/24' > mpd.conf:12: Incorrect context for: 'set link deny pap chap' > mpd.conf:13: Incorrect context for: 'set link enable chap' > mpd.conf:16: Incorrect context for: 'set ipcp enable vjcomp' > mpd.conf:17: Incorrect context for: 'set bundle enable compression' > mpd.conf:18: Incorrect context for: 'set ccp yes mppc' > mpd.conf:19: Incorrect context for: 'set ccp yes mpp-e40' > mpd.conf:20: Incorrect context for: 'set ccp yes mpp-e128' > mpd.conf:21: Incorrect context for: 'set ccp yes mpp-stateless' > [] quit > Sim, agora você vai ter que configurar o mesmo mpd5.conf, seguindo a doc dele. ------------------------- Histórico: http://www.fug.com.br/historico/html/freebsd/ Sair da lista: https://www.fug.com.br/mailman/listinfo/freebsd ------------------------- Histórico: http://www.fug.com.br/historico/html/freebsd/ Sair da lista: https://www.fug.com.br/mailman/listinfo/freebsd