ну как говориться - с этого и надо было начинать :)
в 8-ке lsusb нету - там другая реализация юсб, поэтому и нету. Соответсвенно если софт использует дополнительные тулзы типа lsusb то нифига и не работает. Так что купите нормальный бесперебойник или поставьте 7-ку On Wed, Jul 06, 2011 at 10:42:29PM +0300, Oleg V. Nauman wrote: > Quoting "Vladislav V. Prodan" <univers...@ukr.net>: > > >Решил таки прикрутить мониторинг к UPS по USB. Но наткнулся на > >проблемы с правами. > > > ># usbconfig > >ugen0.1: <OHCI root HUB ATI> at usbus0, cfg=0 md=HOST spd=FULL > >(12Mbps) pwr=SAVE > >ugen1.1: <OHCI root HUB ATI> at usbus1, cfg=0 md=HOST spd=FULL > >(12Mbps) pwr=SAVE > >ugen2.1: <EHCI root HUB ATI> at usbus2, cfg=0 md=HOST spd=HIGH > >(480Mbps) pwr=SAVE > >ugen3.1: <OHCI root HUB ATI> at usbus3, cfg=0 md=HOST spd=FULL > >(12Mbps) pwr=SAVE > >ugen4.1: <OHCI root HUB ATI> at usbus4, cfg=0 md=HOST spd=FULL > >(12Mbps) pwr=SAVE > >ugen5.1: <EHCI root HUB ATI> at usbus5, cfg=0 md=HOST spd=HIGH > >(480Mbps) pwr=SAVE > >ugen6.1: <OHCI root HUB ATI> at usbus6, cfg=0 md=HOST spd=FULL > >(12Mbps) pwr=SAVE > >ugen0.2: <USB to Serial Cypress Semiconductor> at usbus0, cfg=0 > >md=HOST spd=LOW (1.5Mbps) pwr=ON > > > >#cat ups.conf > >[ups] > > driver = megatec_usb > > port = "/dev/ugen0.2" > > desc = "Mustek PowerMust 2000" > > > >Нифига. > ># /usr/local/libexec/nut/megatec_usb -a ups -DD > >Network UPS Tools - Megatec protocol driver 1.6 (2.4.1) > >Serial-over-USB transport layer 0.10 > >debug level is '2' > >No appropriate HID device found > >No supported devices found. Please check your device availability > >with 'lsusb' > >and make sure you have an up-to-date version of NUT. If this does not help, > >try running the driver with at least 'vendorid' and 'subdriver' options > >specified. Please refer to the man page for details about these options > >(man 8 megatec_usb). > >Please report your results to the NUT user's mailing list > ><nut-upsu...@lists.alioth.debian.org>. > > > >Но если запускаешь под рутом, то данные снимаются! > > > ># /usr/local/libexec/nut/megatec_usb -a ups -u root -DD > >Network UPS Tools - Megatec protocol driver 1.6 (2.4.1) > >Serial-over-USB transport layer 0.10 > >debug level is '2' > >Checking device (0665/5161) (/dev/usb//dev/ugen0.2) > >- VendorID: 0665 > >- ProductID: 5161 > >- Manufacturer: Cypress Semiconductor > >- Product: USB to Serial > >- Serial Number: unknown > >- Bus: /dev/usb > >Trying to match device > >Device matches > >DTR=1, RTS=0 > >Starting UPS detection process... > >Asking for UPS information [I]... > >I => FAILED [short read] > >Asking for UPS status [Q1]... > >Q1 => OK [(230.1 230.5 224.1 025 50.1 27.2 25.0 00001001] > >Q1 VALUES => [230.1 230.5 224.1 25.0 50.1 27.2 25.0 00001001] > >Asking for UPS status [Q1]... > >^CQ1 => OK [(228.6 228.1 224.1 025 50.1 27.2 25.0 00001001] > >Q1 VALUES => [228.6 228.1 224.1 25.0 50.1 27.2 25.0 00001001] > >Asking for UPS status [Q1]... > >^CQ1 => OK [(227.2 227.2 221.7 024 50.1 27.2 25.0 00001001] > >Q1 VALUES => [227.2 227.2 221.7 24.0 50.1 27.2 25.0 00001001] > >Asking for UPS status [Q1]... > >Q1 => OK [(228.1 228.6 221.4 025 50.1 27.2 25.0 00001001] > >Q1 VALUES => [228.1 228.6 221.4 25.0 50.1 27.2 25.0 00001001] > >Asking for UPS status [Q1]... > >Q1 => OK [(226.7 226.7 221.4 025 50.0 27.2 25.0 00001001] > >Q1 VALUES => [226.7 226.7 221.4 25.0 50.0 27.2 25.0 00001001] > >0 out of 5 detection attempts failed (minimum failures: 2). > >Cancelling any pending shutdown or battery test. > >Asking for UPS information [I]... > >I => FAILED [short read] > >Megatec protocol UPS detected. > >Parameter [ignoreoff]: [false] > >Asking for UPS power ratings [F]... > >F => OK [#220.0 007 24.00 50.0] > >F VALUES => [220.0 7.0 24.0 50.0] > >24.0V battery, interval [19.4V, 27.4V]. > >Done setting up the UPS. > >Asking for UPS status [Q1]... > >Q1 => OK [(226.2 226.2 221.4 024 50.0 27.2 25.0 00001001] > >Q1 VALUES => [226.2 226.2 221.4 24.0 50.0 27.2 25.0 00001001] > >Calculated battery charge: 97.5% > >dstate_init: sock /var/db/nut/megatec_usb-ups open on fd 6 > >Signal 2: exiting > > http://lists.alioth.debian.org/pipermail/nut-upsuser/2007-March/002513.html > > > > > > >-- > >Vladislav V. Prodan > >VVP24-UANIC > >+380[67]4584408 > >+380[99]4060508 > >vla...@jabber.ru > > > -- ------------------------------------------------------------------------------- Vasiliy P. Melnik VPM-UANIC
