On 5/12/2020 10:52 AM, Mattia Limonta wrote:
But... there are some issues with the serial ports. I am trying to
figure out the issue, but I guess the serial port on the clone system
is too fast for the metal analyzer hardware, and the software gets
stuck on a "Configuring ICS..." screen that on the IBM lasts about 3
seconds and then launches the full program.
Can someone help me on this? I tried exploring the MODE command, but I
couldn't figure out much...
Isn't the analyzer software setting the serial ports parameters? If not,
were there any MODE commands for the serial ports in the autoexec.bat
file on the old PS/2?
Another possibility is that the clone you are running now is using a
less capable UART (16450 instead of 16550, for example) or one of those
with a bad FiFo buffer...
Ralf
--
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
Freedos-user mailing list
Freedos-user@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/freedos-user
