I have that exact same card in a Pentium 133 system. It's a good card. This sounds silly, but try removing and reseating the card in the slot. Really ... I've had cards that have been installed for ages where the electrical contact on the pins oxidizes and then the card becomes flakey, and this specific card has done that to me. If you have "tuner cleaner" or some other electronic contacts cleaner, use that on the card edge connector.
The MAC address should not be FF:FF:FF:FF:FF:FF - that is a sign of a communication problem with the card or a hardware fault. You should check your BIOS settings for any sign of a conflict with another card, but PCI BIOSes are pretty good about that so that is probably not your problem. Mike On Mon, Jul 26, 2021 at 2:25 AM Richard Hoffman < richardhoffman2...@gmail.com> wrote: > Hi, > > I have been having trouble setting up my ethernet card on my freedos > installation. I am currently attempting to set up this card with the > LNE100TX.com packet driver. > > I run the driver with LNE100TX 0x60 and I get the following > > Autonegotiation Not Complete > Packet Driver Interrupt Number 0X60 > IO Port 0xDC00 > Hardware Interrupt Number 11 > Media Type Is 100baseTX Full Duplex > My Ethernet Address Is FF:FF:FF:FF:FF:FF > Packet Driver is loaded at segment 3C2 > > I have my network wired from my DSL router to an 8 port 10/100 mbps > switch. From there it goes to my windows 10 pc and my freedos pc. > > I have tried about every switch option with the packet driver and I keep > getting the same result. Is this a hardware problem with the ethernet card > or is it a router issue? > > Also could this be an IRQ conflict? > > Thanks. > _______________________________________________ > Freedos-user mailing list > Freedos-user@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/freedos-user >
_______________________________________________ Freedos-user mailing list Freedos-user@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/freedos-user
