Provide actual documentation for the pclk and hdisplay calculations in
the case of DSC compression being used.
Signed-off-by: Dmitry Baryshkov <dmitry.barysh...@linaro.org>
---
drivers/gpu/drm/msm/dsi/dsi_host.c | 35 ++++++++++++++++++++++++++++--
1 file changed, 33 insertions(+), 2 deletions(-)
diff --git a/drivers/gpu/drm/msm/dsi/dsi_host.c
b/drivers/gpu/drm/msm/dsi/dsi_host.c
index 3f6dfb4f9d5a..72c377c9c7be 100644
--- a/drivers/gpu/drm/msm/dsi/dsi_host.c
+++ b/drivers/gpu/drm/msm/dsi/dsi_host.c
@@ -528,6 +528,21 @@ void dsi_link_clk_disable_v2(struct msm_dsi_host *msm_host)
clk_disable_unprepare(msm_host->byte_clk);
}
+/*
+ * Adjust the pclk rate by calculating a new hdisplay proportional to
+ * the compression ratio such that:
+ * new_hdisplay = old_hdisplay * compressed_bpp / uncompressed_bpp
+ *
+ * Porches do not need to be adjusted:
+ * - For the VIDEO mode they are not compressed by DSC and are passed as is.
+ * - For the CMD mode the are no actual porches. Instead they represent the
+ * overhead to the image data transfer. As such, they are calculated for the
+ * final mode parameters (after the compression) and are not to be adjusted
+ * too.
+ *
+ * FIXME: Reconsider this if/when CMD mode handling is rewritten to use
+ * refresh rate and data overhead as a starting point of the calculations.
+ */
static unsigned long dsi_adjust_pclk_for_compression(const struct
drm_display_mode *mode,
const struct drm_dsc_config *dsc)
{
@@ -926,8 +941,24 @@ static void dsi_timing_setup(struct msm_dsi_host
*msm_host, bool is_bonded_dsi)
if (ret)
return;
- /* Divide the display by 3 but keep back/font porch and
- * pulse width same
+ /*
+ * DPU sends 3 bytes per pclk cycle to DSI. If compression is
+ * not used, a single pixel is transferred at each pulse, no
+ * matter what bpp or pixel format is used. In case of DSC
+ * compression this results (due to data alignment
+ * requirements) in a transfer of 3 compressed pixel per pclk
+ * cycle.
+ *
+ * If widebus is enabled, bus width is extended to 6 bytes.
+ * This way the DPU can transfer 6 compressed pixels with bpp
+ * less or equal to 8 or 3 compressed pyxels in case bpp is
+ * greater than 8.
+ *
+ * The back/font porch and pulse width are kept intact. They
+ * represent timing parameters rather than actual data
+ * transfer.
+ *
+ * XXX: widebus is not supported by the driver (yet).
*/
h_total -= hdisplay;
hdisplay =
DIV_ROUND_UP(msm_dsc_get_bytes_per_line(msm_host->dsc), 3);
--
2.39.2
