Can you send me a --debug output of your checkout and commit of one of the sections below that doesn't work. If you could use --section=674_FAN1, that'll help lesson the output.
Thanks, Al On Wed, 2013-12-11 at 09:53 +1100, Jean-Yves Avenard wrote: > Hi. > > On 11 December 2013 05:56, Albert Chu <[email protected]> wrote: > > Is it possible the threshold field was commented out by default and you > > forgot to uncomment the field? > > the config file is as generated by the toolt itself. > > the entry doesn't appear commented out: > > Section 674_FAN1 > ## Possible values: Yes/No > Enable_All_Event_Messages > Yes > ## Possible values: Yes/No > Enable_Scanning_On_This_Sensor > Yes > ## Possible values: Yes/No > Enable_Assertion_Event_Lower_Critical_Going_Low > Yes > ## Possible values: Yes/No > Enable_Assertion_Event_Lower_Non_Recoverable_Going_Low > Yes > ## Possible values: Yes/No > Enable_Assertion_Event_Upper_Critical_Going_High > Yes > ## Possible values: Yes/No > Enable_Assertion_Event_Upper_Non_Recoverable_Going_High > Yes > ## Possible values: Yes/No > Enable_Deassertion_Event_Lower_Critical_Going_Low > Yes > ## Possible values: Yes/No > Enable_Deassertion_Event_Lower_Non_Recoverable_Going_Low > Yes > ## Possible values: Yes/No > Enable_Deassertion_Event_Upper_Critical_Going_High > Yes > ## Possible values: Yes/No > Enable_Deassertion_Event_Upper_Non_Recoverable_Going_High > Yes > ## Give valid input for sensor type = Fan; units = RPM > Lower_Non_Critical_Threshold > 500.000000 > ## Give valid input for sensor type = Fan; units = RPM > Lower_Critical_Threshold > 350.000000 > ## Give valid input for sensor type = Fan; units = RPM > Lower_Non_Recoverable_Threshold > 200.000000 > ## Give valid input for sensor type = Fan; units = RPM > Upper_Non_Critical_Threshold > 18975.000000 > ## Give valid input for sensor type = Fan; units = RPM > Upper_Critical_Threshold > 19050.000000 > ## Give valid input for sensor type = Fan; units = RPM > Upper_Non_Recoverable_Threshold > 19125.000000 > ## Give valid input for sensor type = Fan; units = RPM; 'None' to not > use hysteresis > Positive_Going_Threshold_Hysteresis > 75.000000 > ## Give valid input for sensor type = Fan; units = RPM; 'None' to not > use hysteresis > Negative_Going_Threshold_Hysteresis > 75.000000 > EndSection > > > > > > If the field is commented out by default, it likely means the field is > > not settable on the motherboard. > > I can't be certain it's not commented out; but it doesn't appear so > > > > > If by chance you know for fact it is settable (such as via a Supermicro > > specific tool), that means there is a bug on the motherboard advertising > > the wrong information. I'd have to implement a workaround to deal with > > it. > > I can set the threshold using the ipmiutil like so: > ipmiutil sensor -N 192.168.10.251 -U ADMIN -R "password" -n 41 -i 0x02a2 -l > 0x04 > > so it's definitely writeable. > > Hope this help > JY -- Albert Chu [email protected] Computer Scientist High Performance Systems Division Lawrence Livermore National Laboratory _______________________________________________ Freeipmi-users mailing list [email protected] https://lists.gnu.org/mailman/listinfo/freeipmi-users
