Make sure your $PATH is correct. Sounds like Radiusd isn't in your
$PATH.
/L
Den 28/10/2006 kl. 17.29 skrev Chad Best:
This is a total newbie question, but I can figure out the answer to
it so I decided to post here. I have installed Freeradius-1.0.0
(little behind the times, I know).
After I finished configuring the radiusd.conf, eap.conf, and users
files, I tried to start FreeRadius in debug mode. However, when I
type "radiusd -X", I get command not found. What did I do wrong?
When I installed the program, I just ran ./configure, make, make
install so it should have installed properly.
Any help would be greatly appreciated.
-
List info/subscribe/unsubscribe? See http://www.freeradius.org/list/
users.html
-
List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html
