Hi Sam
have you tried running the post-hoc surface deformation on the 0.7mm
data? Jon Polimeni (ccd) has experience with this and might be able to help
you out (or Matt Glasser for that matter)
cheers
Bruce
On Wed, 9 Apr 2014, Torrisi, Sam (NIH/NIMH) [F] wrote:
Good afternoon gurus-
I’m new to FS and working with 0.7mm iso 7T MPRAGEs. After bias-correction with
AFNI’s 3dUnifize, recon-all ran without hitch but downsampled everything to
1mm. Now I have basically the same sentiment and question as this thread from
~2 years ago (i’m linking to the middle for simplicity):
http://www.mail-archive.com/freesurfer%40nmr.mgh.harvard.edu/msg22852.html
What’s the very latest on this? Thanks!
-Salvatore (Sam) Torrisi
Section on the Neurobiology of Fear and Anxiety
National Institute of Mental Health
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
