Dear experts,
I had a question regarding the output of my Qdec analyses. When I run a
Monte Carlo Z simulation on my results, I get the following output:
# ClusterNo Max VtxMax Size(mm^2) TalX TalY TalZ CWP
CWPLow CWPHi NVtxs Annot
1 2.930 94685 921.76 -48.9 -7.0 41.2 0.02170
0.01980 0.02360 2096 precentral
2 2.525 33091 935.62 -21.2 22.2 35.2 0.01950
0.01770 0.02130 1634 superiorfrontal
When I then press the 'find cluster and goto max' button, I get a different
output:
Generating cluster stats using min threshold of 1.3...
Found 2 clusters
Contrast: 'lh-Avg-thickness-SensTOTAV-Cor', 10fwhm, DOF: 185
ClusterNo Max VtxMax Size(mm2) TalX TalY TalZ NVtxs Annotation
--------- --- ------ --------- ---- ---- ---- ----- ----------
1 1.7100 109 935.62 -22.7 24.0 51.0 1634
superiorfrontal
2 1.6635 12 921.76 -52.5 -6.6 38.5 2096 precentral
============================================================
I am assuming that that the second output gives the coordinates of the max
significant vertex. What does the first set of coordinates refer too? I
think it may the cluster's centre of mass, but I am not sure. Thank you!
Kind regards,
Las
_______________________________________________
Freesurfer mailing list
[email protected]
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
