yes, you have to create a segmentation in $SUBJECTS_DIR/$subject/mri in the same format as aseg.mgz, then when you run fcseed-config, specify -seg yourseg.mgz -segid yoursegid
On 03/29/2018 05:36 AM, Piero Chiacchiaretta wrote: > > Thanks Doug. > > My goaI is to perform a FC analysis of cerebellum subregions using > FS-FAST. I understand that FS do not permit the segmentazion for > 601-602. Anyway, do you think that I can use as seed the cerebellar > regions defined by Buckner et > al.(http://www.freesurfer.net/fswiki/CerebellumParcellation_Buckner2011)? > Have you alternative way or any suggestion? > > Best regards > > Piero > > > Piero Chiacchiaretta, PhD > Institute for Advanced Biomedical Technologies - ITAB - > University “G. d’Annunzio” of Chieti - Pescara > Department of Neuroscience, Imaging and Clinical Sciences > Via dei Vestini, 31 > 66013 Chieti, Italy > > tel: 39-0871-3556919 <tel://tel:%2039-0871-3556919> > fax: 39-0871-3556930 <tel://fax:%2039-0871-3556930> > e-mail: p.chiacchiare...@unich.it <mailto:p.chiacchiare...@unich.it> > > > _______________________________________________ > Freesurfer mailing list > Freesurfer@nmr.mgh.harvard.edu > https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer _______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
