I assume you have your document setup as two pages in FusionPro
Desktop, is that correct?
When you create your imposition, on the Document tab, enter 2 in the
Pages Per Record box. Then on the Layout tab, select Duplex Perfected.
That should be all there is to it.
John
At 06:11 PM 4/7/2007, you wrote:
I'm setting up TWO 3-up impositions -- one for the FRONT of a postcard, one
for the BACK.
When defining the value of the Graphic Frame in each of my Imposition PDF
templates, how do I tell FusionPro to use page ONE of the Output PDF for the
front, and page TWO of the Output PDF for the BACK?
If I simply assign my Output PDF as my Graphic Frame value, it will just
show page one, of course.
How do I get around that?
Thanks in advance. . .
--
Users of FusionPro Desktop have unlimited free email support. Contact Printable Support at [EMAIL PROTECTED]
--
View FusionPro Knowledge Base, FusionPro Samples at
www.printable.com/vdp/desktop.htm
--
You are currently subscribed to fusionpro as: archive@mail-archive.com
To unsubscribe send a blank email to [EMAIL PROTECTED]
--
--
Note: All e-mail sent to or from this address will be received or otherwise
recorded by the e-mail recipients of this forum. It is subject to archival,
monitoring or review by, and/or disclosure to someone other than the recipient.
Our privacy policy is posted on www.printplanet.com
--