Just not so in our experience... We had SEVERAL template we made in 3.x
that had horiz and vertical placements and the stacking was set to 2500
in the last column. (2500 on most of these particular jobs, yields us a
cartfull)..
Moved to 4.1 and the stacking did not work UNLESS we made it the first
entry then added the horizontal and vertical steps in the remaining fields..
(Step and repeat columns) 3.x
H V Stack
2 2 2500
(Step and repeat columns) 4.x
Stack H V
2500 2 2
When I say stacking did not work, I refer to a 2500 (5000 record) 2-up run
Done "the old way" - first card printed would have sequence #1 on top
position and sequence #2 at the bottom.
Move the stacking to the first "column" in Inposer and it would be 1 and
2501 (as it should be)..
Didn't know about the ODBC issue, though..
Mark Hardee
Director of Digital Services
Mercury Printing
A Consolidated Graphics Company
4650 Shelby Air Drive
Memphis, TN 38118
Plant: 901-345-8480
Direct: 901-462-3464
--
Users of FusionPro Desktop have unlimited free email support. Contact Printable Support at [EMAIL PROTECTED]
--
View FusionPro Knowledge Base, FusionPro Samples at
www.printable.com/vdp/desktop.htm
--
You are currently subscribed to fusionpro as: [EMAIL PROTECTED]
To unsubscribe send a blank email to [EMAIL PROTECTED]
--
--
Note: All e-mail sent to or from this address will be received or otherwise
recorded by the e-mail recipients of this forum. It is subject to archival,
monitoring or review by, and/or disclosure to someone other than the recipient.
Our privacy policy is posted on www.printplanet.com
--
