Hi, Define the Pool under Address Ranges.
Then under the Global Properties -> Nat -Netw. Addr. Trans. tick the 'Enable IP Pool Nat for SR/SC ....' Then go to your Firewall Module Object and on the NAT use the Pool you just defined. Met vriendelijke groeten - Bien � vous - Kind regards Guy ROELANDTS EMEA GS Internet Expertise Centre - CCSE-NG Hewlett-Packard Belgium B.V.B.A./S.P.R.L. E-mail : [EMAIL PROTECTED] Tel: +32(02)729.77.44 (options 3 - 3 - 1) Fax: +32(02)729.77.65 ========================================================== This message may contain confidential and/or proprietary information, and is intended only for the person/entity to whom it was originally addressed. The content of this message may contain private views and opinions which do not constitute a formal disclosure or commitment unless specifically stated. Should you receive this message by mistake please inform the sender immediately. ========================================================== -----Original Message----- From: boobe jouke [mailto:[EMAIL PROTECTED] Sent: 12 March 2003 04:10 To: [EMAIL PROTECTED] Subject: [FW-1] IP Pool for remote client I have just installed my NG firewall and would like to know where to dfine the IP POOL for my remote clients ? _________________________________________________________________ STOP MORE SPAM with the new MSN 8 and get 2 months FREE* http://join.msn.com/?page=features/junkmail ================================================= To set vacation, Out Of Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] ================================================= ================================================= To set vacation, Out Of Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
