hi,
is 148.x.x.x your internal network?
did you enable NAT?
cheers
reinhard
-----Ursprüngliche Nachricht-----
Von: Horacio Paredes [mailto:[EMAIL PROTECTED]
Gesendet: Mo 30.06.2003 18:45
An: [EMAIL PROTECTED]
Cc:
Betreff: [FW-1] CP NG FP3 cant work with 2 different ip address ranges...
Hi everybody!!
I tried to migrate a PIX to CP NG FP3 in recent days
but I had to recover the PIX, because when I
configured CP FW-1 with a IP address on the outside
interface (i.e. 200.x.x.x) and all the NAT´s are using
the range of 148.x.x.x. All services (148.x.x.x) are
not seen from internet only the addresses 200.x.x.x.
The CISCO Pix is working fine with this scheme.
What do you think is the problem with this???
Regards,
Horacio
Security Engineer
_________________________________________________________
Do You Yahoo!?
La mejor conexión a internet y 25MB extra a tu correo por $100 al mes.
http://net.yahoo.com.mx
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [EMAIL PROTECTED]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[EMAIL PROTECTED]
=================================================
