We have been trying to set up the FW-1's protecting various subnets from our production back bone network to support IP Multicast...the MS Media Saerver and Vbrick units are on the production backbone and IP Multicast to all subnets (without FW-1 firewalls) and subnet switches fine....However when the IP multicast hits those subnets protected by the FW-1's...on the protected side of the firewall...the protocol changes to unicast and broadcast to all ports on the switch....we are using cisco switces and have enabled multicast options and protocols on them...we know that the work...the problem seems to be the FW-1 not enabling Multicast thru from the production backbone to the FW-1 protected subnets can any one assist with a solution...I am sure that we are not the only ones with this problem...Best Regards...Phil
Phillip Rene Bureau of Labor Statistics 2 Mass Ave Washington DC 20212 202-691-7532 [EMAIL PROTECTED] ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
