Ben, This has been discussed in the past on this mailing list or on the one from PhoneBoy ... It was said there you only had to remove the product.conf file to start over again ...
Met vriendelijke groeten - Bien � vous - Kind regards Guy ROELANDTS EMEA GS Internet Expertise Centre - CCSE-NG Hewlett-Packard Belgium B.V.B.A./S.P.R.L. E-mail : [EMAIL PROTECTED] Tel: +32(02)729.85.61 Fax: +32(02)729.77.65 ========================================================== This message may contain confidential and/or proprietary information, and is intended only for the person/entity to whom it was originally addressed. The content of this message may contain private views and opinions which do not constitute a formal disclosure or commitment unless specifically stated. Should you receive this message by mistake please inform the sender immediately. ========================================================== -----Original Message----- From: Ben Cuthbert [mailto:[EMAIL PROTECTED] Sent: Tuesday, September 02, 2003 5:07 PM To: [EMAIL PROTECTED] Subject: [FW-1] NG FP2 cpconfig -- reset All I remember in 4.1 you were able to reset cpconfig by removing the products.conf file, how does one go about doing it in NG. __________________________________________________ Yahoo! Plus - For a better Internet experience http://uk.promotions.yahoo.com/yplus/yoffer.html ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] ================================================= ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
