Hello, You should not have to modify the initial policy and I would also not recommend doing this, as this is part of the boot protection of your firewall.
After boot, the firewall module will connect to the management station and fetch the policy if it is necessary. If it sees that the local policy and remote policy are the same it will install a local copy of the saved policy. If it sees the copy on the management server is newer, it will do a fetch and install the new policy. Regards, Werner -----Original Message----- From: Martin Blankestijn [mailto:[EMAIL PROTECTED] Sent: Tuesday, September 16, 2003 11:46 AM To: [EMAIL PROTECTED] Subject: [FW-1] Howto replace the initial policy with the current installed policy Hi, How can I replace the initial policy with the current installed policy so that after a reboot my current rulebase is installed automatically We run: NG - FP3 on SecurePlatform thanks in advance Martin ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] ================================================= ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
