This is due to the FWM process which will be reset with the new policy install or cp stop and start. There is a work around this, what IPSO are you running?
-----Original Message----- From: Mailing list for discussion of Firewall-1 [mailto:[EMAIL PROTECTED] On Behalf Of Tobias Lachmann Sent: Saturday, December 06, 2003 11:33 AM To: [EMAIL PROTECTED] Subject: [FW-1] AW: [FW-1] Processor load >100% after policy install Hello! I've seen the same on our Secure Platform with NG AI R54 in a cluster-environment. I found that you don't have to do cprestart, only a policy re-install is needed the get the CPU utilization to the normal level again. Regards, Tobias -----Urspr�ngliche Nachricht----- Von: Michael Schwartzkopff [mailto:[EMAIL PROTECTED] Gesendet: Samstag, 6. Dezember 2003 07:57 An: [EMAIL PROTECTED] Betreff: [FW-1] Processor load >100% after policy install Hi, we experienced a strange problem: Suddenly the processor load of our firewall module shot up to 100% and stayed there until we did a cprestart. It seemed that the trigger of this event might have been the installation of a new policy. Our OS: Solaris8. Has anyone seen something similar? M. Schwartzkopff ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] ================================================= ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] ================================================= ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
