I have Nokia IP40s (with dynamic addresses) at each of two remote sites to terminate VPNs back to our main office, which is NG FP3 on the enforcement points and R55 on the management. Both of these two remote sites are in the same VPN community as satellites with the main office firewall as the central gateway. For VPN routing, the community is set up "To center and to other satellites through center". I am trying to get these two remote sites to talk...
On the management console, I edited the vpn_route.conf file as follows: IP40_1_ProtectedNetwork CentralGW IP40_2 IP40_2_ProtectedNetwork CentralGW IP40_1 When I push police from my management console, I get the following: add_install_on_gw_to_set: install on gw object is not a firewall (IP40_1) add_install_on_gw_to_set: install on gw object is not a firewall (IP40_2) Any ideas on how to get this to work? Is VPN routing even supported with IP40s? ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
