I think if you use 0.0.0.0 as the NAT address it takes the address of the external interface.....
IAn -----Original Message----- From: Mailing list for discussion of Firewall-1 [mailto:[EMAIL PROTECTED] Behalf Of Davis, Nathaniel Sent: 06 April 2004 13:14 To: [EMAIL PROTECTED] Subject: [FW-1] REPOST: DHCP on NG AI R54 Hi all. I have configured an interface on my IP330 to grab a DHCP address from my ISP. My question is, how do I configure SmartDashboard to dynamically NAT to the dhcp'd address without having to manually change the each rule? TIA. Nathan ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] ================================================= ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
