Hi Lyle! I had this same problem, same config... I was using hiding NAT for the other network. I had to use static nat to fix the problem.
Hope this helps. Jo�o. On Fri, 19 Nov 2004 07:16:20 -0800, Lyle Dove <[EMAIL PROTECTED]> wrote: > Hello, > > I have the following configuration > > Nokia IP380, IPSO 3.5.1, NG-AI FP3 > > We have a MS network in which we have mapped drives which traverse through > the FW from one network to another. The problem is that after a short > period of time, the shares/mapped drives appear to timeout. Once we > attempt to access the shares/drives again, it takes a few seconds for them > to 're-sync' and then everything works fine again. If we go to the same > network segment, and then map the drives, they work as expected, and don't > timeout. Is there something in the FW configuration that I can check that > may cause this? > > Thanks, > > -------- > Beep! Beep! > > Lyle Dove > BPS Senior Technician > Time Warner Cable - Los Angeles Division > > "The information transmitted is intended only for the person or entity to > which it is addressed and may contain confidential, proprietary, and/or > privileged material. Any review, retransmission, dissemination or other use > of, or taking of any action in reliance upon, this information by persons or > entities other than the intended recipient is prohibited. If you received > this in error, please contact the sender and delete the material from all > computers." > > ================================================= > To set vacation, Out-Of-Office, or away messages, > send an email to [EMAIL PROTECTED] > in the BODY of the email add: > set fw-1-mailinglist nomail > ================================================= > To unsubscribe from this mailing list, > please see the instructions at > http://www.checkpoint.com/services/mailing.html > ================================================= > If you have any questions on how to change your > subscription options, email > [EMAIL PROTECTED] > ================================================= > ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
