A lot of times the cause of the error message you described, is caused because the management server is out of disk space. Check the available disk space on the management server, if it's close to capacity, clear out some of the CP logs and then try your connection again.
-----Original Message----- From: Mailing list for discussion of Firewall-1 [mailto:[EMAIL PROTECTED] Behalf Of Shaun Shaver Sent: Tuesday, February 01, 2005 2:54 PM To: [email protected] Subject: Re: [FW-1] Having problems to connect Smartdashboard I just had this problem trying to set up a stand by firewall. In my case the internal interface address on the gateway was different than what I set it to be in the web admin. I had to... Go to the local console and login Type "fwm unload 'your gateway name'" Go back to smart dashboard and login Check the internal network address in the gateway properties (under topology) If it's not the same as the address you specified when trying to log into smart dashboard then change it to that address. There might be a better way but this was how I did it. -----Original Message----- From: Mailing list for discussion of Firewall-1 [mailto:[EMAIL PROTECTED] On Behalf Of Eduardo Notari Sent: Tuesday, February 01, 2005 12:14 PM To: [email protected] Subject: [FW-1] Having problems to connect Smartdashboard Hello, I�m having problem to connect the SmartDashBoard to the SmartCenter. This is the message that appear: "Connection cannot be initiated. Please make sure that the Server "192.168.0.3" ia up and running and that you are defined as a GUI Client." I was connecting and now I can�t do it. I am defined as a GUI Client and the network configurations are ok. Does anyone know what I can do? Thanks, Notari ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] ================================================= ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] ================================================= ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
